S-101
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phones: +420 582 309 146+ (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
Revised 09/2004
1-18
TO ADJUST THE ROCKER ARM AND STOP MOTION
Crank the machine with L.H. handwheel, to its stopping position. With the R.H. handwheel
(knurled rim) turn until dog
n
is in contact with the stop bolt
o
- when in this position roller
p
should have a very light contact on low point of cam
q
on handwheel. Make adjustment by
loosening screw
r
(Figure 3a) and swing rocking lever to suit. See note at bottom left of
sheet.
With the L.H. handwheel, crank the machine until the
rocking lever is as far back as it will go. (at this
point the dog
n
and the stop bolt
o
are about 1/8“
apart at (Figure 2a).
Note:
Also that roller
t
is at the
peak of gauge
u
.
When the parts are in the
position shown there must be
a clearance of about 1/32“ at
- if not - adjust by
loosening nut
v
and raise or
lower lever
w
to suit.
Note:
Before tightening screw
r
be sure parts
s
and both
bear against sides of the
boss on head casting.
Important:
Before making these adjustments
be sure that the adjustments on
sheet 16 (Pressure on length
gauge) are correct.
n
p
q
o
n
o
s
t
u
v
w
r
MACHINE ADJUSTMENTS - CORRECTIVE AND MAINTENANCE