Ametek Jofra ETC-125 A, Справочное руководство

Страница: 34 / 86

123943 08 2019-04-12 7
•
Only use a mains power cord with a current rating as
specified by the calibrator and which is approved for
the voltage and plug configuration in your area.
•
Before switching on the calibrator make sure that it is
set to the voltage of the mains electricity supply.
•
Always position the calibrator to enable easy and quick
disconnection of the power source (mains inlet socket).
•
The calibrator must be kept free within an area of 20
cm on all sides and 1 metre above the calibrator due to
fire hazard.
•
Never use heat transfer fluids such as silicone, oil,
paste, etc. in the calibrators. These fluids may
penetrate the calibrator and cause electrical hazard,
damage or create poisonous fumes.
•
The calibrator must be switched off before any attempt
to service the instrument is made. There are no user
serviceable parts inside the calibrator.
•
When cleaning the well or the insertion tube,
REMEMBER to wear goggles when using compressed
air in the dry-block calibrator.
•
Avoid knocking, bumping or dropping the instrument.
This can cause permanent damage to the instrument
and loss of accuracy.
•
Do not use this instrument for any application other
than calibration work.
•
The calibration instruments should only be used by
TRAINED PERSONNEL.
About the insertion tubes and well:
•
Never leave hot insertion tubes which have been
removed from the calibrator unsupervised – they may
constitute a fire hazard or personal injury.
•
If you intend to store the calibrator in the optional
aluminium carrying case after use, you must ensure
that the instrument has cooled down to a temperature
below 100°C/212°F before placing it in the carrying
case.