Ametek CHANDLER ENGINEERING 5265, Инструкция по эксплуатации

Страница: 7 / 42

PREFACE P-3
Safety Requirements
READ BEFORE ATTEMPTING OPERATION OF INSTRUMENT
If this equipment is not used in a manner consistent with the
manufacturer’s specifications the protection provided by the equipment
may be impaired.
Warning: Read before attempting operation of this instrument.
This instrument is capable of high temperatures and pressures and must
always be operated with CAUTION. The instrument is designed for
operator safety. To ensure that safety, it is essential the general instructions
out lined below are followed. This instrument should only be operated by
trained personnel that have completed the appropriate safety training.
Warning: High Temperatures
During a test, the instrument can become hot and cause injury if touched.
All ow the cylinder to cool to below 95
o
F (35
o
C) prior to touching.
The following safety procedures are advisable:
•
Post signs where the instrument is being operated to warn other personnel.
•
Read and understand the instructions and caution notes before attempting
operation.
•
Never exceed the instrument maximum pressure and temperature ratings. The
particular safety requirements associated with the handling and use of the
medium to be tested, especially the additional requirements associated with
handling potentially flammable liquids or otherwise hazardous agents are the
responsibility of the customer – proper precautions must be taken to reduce
the risk of fire or explosion.
•
Use appropriate Personal Protective Equipment such as safety glasses, latex
gloves, etc.
•
This is a bench top device; place the instrument on a suitable, level, and stable
surface.
•
Locate the instrument in a low traffic area. Allow a minimum of 12 in.
(305mm) unobstructed clearance around side, back and top faces to provide
for adequate ventilation. Position the back of the instrument to allow access
to disconnect cords in the event of an emergency.
•
Always disconnect main power to the instrument before attempting any repair.
•
Have the safety officer at your location review the safety aspects of the
instrument and this manual and approve the operational and installation
procedures.
•
Turn off the heater at the completion of a test. Hot water in the open cylinder
or drain, when exposed to the atmosphere and heated beyond its boiling point,
can cause server burns from steam.