AmeriGlide Hercules 750 Residential, Руководство по установке

Страница: 5 / 25

The VPL must only be installed on an approved pad or floor that has adequate drainage and meets local codes, standards
and regulations. In addition, there must be adequate lighting and sufficient headroom above the lift. Please refer to and
verify with the Technical Drawings before beginning the install.
Site Requirements
The VPL requires a 110VAC-20 AMP or 110VAC-15 AMP grounded electrical circuit and a GFCI protected circuit.
Depending on local codes and regulations, this connection may need to be routed in electrical conduit and hard-wired.
Electrical Requirements
Installation Safety Instructions
• Never exceed the maximum rated lift capacity.
• Never use the VPL to lift freight or other materials than
intended by design.
• Read and understand the installation guide prior to
installing the VPL.
• Wear appropriate safety protection equipment for
your head, eyes, hands and feet during all phases of
the installation.
• Use extreme caution when lifting components into
position to avoid personal injury and damage to
the equipment.
• Keep panels and protective coverings in place to avoid
potentially fatal injury.
• Disconnect power from the unit before performing
any electrical or mechanical service operations.
WARNING
!
DO NOT OPERATE OR RIDE ON THE LIFT UNTIL IT HAS BEEN ANCHORED TO AN APPROVED
PAD OR FLOOR.
WARNING
!
To reduce the risk of fire, electric shock, personal injuries, and/or death, obey the
following precautions:
4