American TIM-900, Инструкция по установке и эксплуатации

Страница: 32 / 40

32
of the image on the LCD from
deteriorating, thus causing metering
errors.
When the message "bAtt" blinks,
the TOTAL is
constantly updated
,
although not displayed.
To replace the batteries:
A. With a small screwdriver (PH cross
head, bit No. 1) completely screw off
the four screws of the battery pack and
remove it.
B. Open the battery pack by
removing the cover.
C. Remove the flat batteries.
The correct polarity is
shown in the battery
compartment.
D. Install 4 new batteries of type AA
1,5 Volt Alkaline, paying attention to
polarity
shown on the
cover.
TIM-900 will start automatically
as soon as the battery pack is
fixed, carrying out a short
SELF-TEST:
• Complete lighting of LCD
• Complete stop of LCD
• Display of serial number of
electronic board
• Normal operation mode
E.
Place the cover again and fix the
battery pack by screwing the four
screws.
Warning
Warning
The replacement of the batteries
does not cause any data loss.
The customization of the
TIM-900, previously set, remains
operational
at the next re-starting.
The TIM-900 is equipped with a
removable filter for inspection and
cleaning, which is installed inside the
swivel.
Warning
Clogging of the filter can strongly
reduce the maximum flow-rate
supplied by the TIM-900.
Regularly clean the filter, and
check it each time a flow-rate
reduction is detected.
To reduce the frequency of
cleaning operations, the
dispensing system of the TIM-900
should be equipped with suitable
line filters.
Cleaning the filter H2