American TIM-900, Инструкция по установке и эксплуатации

Страница: 16 / 40

Warning
• The TIM-900 has been designed for professional use and must be used only by
adult personnel properly trained for the intended purpose.
• The TIM-900 must not be used outside the operating ranges (see Technical Data
in paragraph M1) or for fluids other than lubricants and antifreeze mixtures.
• Do not tamper with or modify the TIM-900.
• Regularly check the good condition of the TIM-900.
• The TIM-900 dispenses high-pressure fluids. Do not point the nozzle to any part
of the body.
• Use the personal protection equipment recommended by the national standards
relevant to the dispensed products.
• Do not carry out any maintenance operations on the TIM-900 without previously
relieving the pressure from the system lines.
• The TIM-900 is designed for indoor use only. If used outdoors, it must be
sheltered from the rain, snow or direct sunrays.
If the TIM-900 is off, type
RESET to re-start it.
The TIM-900 displays:
The TIM-900 can be used as a normal
nozzle if the Operator does not want
to pre-set an automatic stop value.
The TIM-900 can be programmed to
display the last amount dispensed until
the RESET button is pressed or to
automatically reset the Batch Total a few
minutes after the end of the dispensing
operation in MANUAL mode (see "Auto
RESET" in paragraph G5).
If the last dispensing has been carried
out in AUTO mode, the dispensed
amount is never reset, independent of
the selection of the Auto RESET button.
To dispense in Manual mode
F1
Using the TIM-900
F
Last amount
dispensed.
Non-resettable Total
16
Warning
In case of manual anti-drip valve,after using,
it is important to discharge theoverpressure
between the chamber (1) and themanual valve (2)
of the spout. Carry out this operationwhile the pump
is switched off. Then, unscrew the valve(2). During this discharging
operation, do not push the trigger (3).