American Dryer Corp. AD-310, Руководство по установке

Страница: 19 / 81

15
C. FRESH AIR SUPPLY REQUIREMENTS
When the dryer is operating, it draws in room air, heats it, passes this air through the basket (tumbler), and
exhausts it out of the building. Therefore, the room air
must be continually replenished from the outdoors. If the
make-up air is inadequate, drying time and drying efficiency will be adversely affected. Ignition problems and sail
switch “fluttering” problems may result, as well as premature motor failure from overheating.
Air supply (make-up air) must be given careful consideration to assure proper performance of each dryer. An
unrestricted source of air is necessary for each dryer. An airflow of 6,500 cfm (cubic feet per minute) 182.2
cmm (cubic meters per minute)
must be supplied to each gas dryer and 8,500 cfm (240.7 cmm) for each steam
dryer. As a general rule, an unrestricted air entrance from the outdoors (atmosphere) of a minimum of 6 square
feet (0.56 square meters) is required for each gas dryer and a minimum of 8 square feet (0.74 square meters) for
each steam dryer.
To compensate for the use of registers or louvers used over the openings, this make-up air area must be
increased by approximately thirty-three percent (33%). Make-up air openings should not be located in an area
directly near where exhaust vents exit the building.
It is not necessary to have a separate make-up air opening for each dryer. Common make-up air openings are
acceptable. However, they
must be set up in such a manner that the make-up air is distributed equally to ALL
the dryers.
Allowances must be made for remote or constricting passageways or where dryers are located at excessive
altitudes or predominantly low pressure areas.
IMPORTANT: Make-up air must be provided from a source free of dry cleaning solvent fumes.
Make-up air that is contaminated by dry cleaning solvent fumes will result in
irreparable damage to the motors and other dryer components.
NOTE: Component failure due to dry cleaning solvent fumes will VOID THE WARRANTY.