6. Launch the board user interface application.
On first use of the board user interface, go to the FMC → Set VADJ → Boot-up tab and click USE
FMC EEPROM Voltage. The board user interface buttons gray out during command execution
and return to their original appearance when ready to accept a new command.
See the ZCU670 System Controller GUI Tutorial (
) and the ZCU670 Software Install and
Board Setup Tutorial (
) for more information on installing and using the system controller
board user interface utility.
Switches
, callouts 23 and 24]
The ZCU670 board includes the following power, configuration, and reset switches:
• SW15 power on/off slide switch (callout 24)
• SW3 (PS_PROG_B), active-Low pushbutton (callout 23)
• SW4 (POR_B), active-Low pushbutton (callout 23)
• SW5 (SRST_B), active-Low pushbutton (callout 23)
• SW2 U1 RFSoC PS bank 503 4-pole mode DIP switch (callout 23)
Power On/Off Slide Switch
, callout 24]
The ZCU670 board power switch is SW15. Sliding the switch actuator from the off to on position
applies 12V power from J50, a 6-pin mini-fit connector. Green LED (DS19) illuminates when the
ZCU670 board power is on. See
for details on the onboard power system.
Chapter 3: Board Component Descriptions
UG1532 (v1.0) March 30, 2022
ZCU670 Board User Guide
57