AMBOSS AMB-50MT-OPTI, Руководство по эксплуатации, Страница: 59 / 93

Version 1.1.1 dated February 25th, 2013 Page 59 Original operating instructions
GB
increased. When the sequence number of the entry of the hole is equal to the entry number
of the subdivided hole press the key
in order to go back to hole No 01. 
Press the key in order to return to the position of the previous hole and the sequence
number of the hole is reduced. When the entry number of the hole is 01 press the key
once again in order to go back to the position of the last hole.
III. After having completed the subdivided hole on the circle machining
press the key in order to go back to the standard display. When you are on the subdivi-
ded hole in the mode circle press the key 
in order to interrupt the function and to return to the standard display except for the above
mentioned cases.
6.14 Machining along the inclined line function
Introduction of the function:
In order to execute the inclined line machining operation on the selected coordinate layer and
to use inclined grooves or inclined layers in the operation.
A description of the parameters has to determine the following points:
- Inclined angle of the inclined line (CL-A): The inclination between the inclined line seg-
ments which are machined and the X axis along the positive direction (on the YZ layer
an inclination between these points and the Y axis along the positive direction).

Proceeding:
I. Entering parameters:

Move the tool of the machine tool to align to the first point of the inclined line which has to
be machined press the key and enter the inclined line machining function. The dis-
play at the top right is displayed and indicates that the angle of the inc-
lined line can now be entered. The X-Y coordinate layer is a standard layer. 
The LEDs on the X axis display the last value of the angle of the inclined line. The new
entered value is displayed on the LEDs on the Y axis.

When you want to change the coordinate layer simply press the key several times
the coordinate layer changes according to the following sequence:
- Change over from the XY coordinate layer to the YZ coordinate layer;
- Change over from the YZ coordinate layer to the XZ coordinate layer;
- After completing the inclined line machining function the position display returns to the
standard display.
- Enter the angle of the inclined line and then press the key to confirm your entry.
When the entered value of the angle is allowed you attain the mode of automatic
machining. The display at the top right displays
at which "30.00" is
at the right of the angle value of the inclined line (except for a decimal fraction); The