Commissioning
7.4
Fitting wheels
If the machine is fitted with inflatable spare tyres, running wheels must
be fitted before putting into operation.
WARNING
•
Only one permitted set of tyres may be used, as specified in
the technical data (see page 55).
•
Wheel rims that are suitable for the tyres used must have a
rim that has been fully welded all the way round.
•
A hydraulic stand extension and ladder extension must be fitted
in the case of tyres with a diameter greater than 1860 mm.
•
Depending on the wheel track, the locking screw must be fitted if
there is a steering axle, see page 82.
1. Lift machine slightly using lifting crane.
DANGER
Use the attachment points marked for lifting belts.
See also "Loading" section, page 39.
2. Loosen wheel nuts on the inflatable spare tyres.
3. Remove inflatable spare tyres.
CAUTION
Take care when removing the inflatable spare tyres and putting
the running wheels in place.
4. Place the running wheels on threaded bolts.
5. Tighten wheel nuts.
Required tightening torque for wheel nuts: 510 Nm.
6. Lower machine and remove lifting belts.
7. After 10 operating hours, tighten wheel nuts.
7.5
Initial operation of service brake system
Perform a brake test while the trailed sprayer is empty, and again
when it is loaded to test the braking behaviour of the tractor with cou-
pled trailed sprayer.
We recommend that you have a specialist workshop coordinate the
brakes on the tractor and trailed sprayer in order to attain optimum
braking and minimum wear to brake linings (see "Maintenance" sec-
tion, page 200).
7.6
Adjusting the hydraulic system with the system setting screw
144
UX Super
BAG0054.10 11.16
