Amazone Centaya 3000 Special, Оригинальное руководство по эксплуатации

Страница: 79 / 160

2.
To define the minimum pressure of the exact
following harrow,
remove the linch pin
3
and insert it in a the
desired hole under the stop
1
. The higher the
hole, the greater the minimum pressure of the
exact following harrow.
3. Relieve the lever and fasten it in the transport
lock.
4.
To define the maximum pressure,
remove the second linch pin
2
and insert it in
the desired hole under the stop
1
. The higher
the hole, the greater the maximum pressure of
the exact following harrow.
3 2 1
CMS-I-00004672
5.
To set the higher exact following harrow
pressure,
actuate the "green 1" tractor control unit
or
To set the lower exact following harrow
pressure,
put the "green" tractor control unit into float
position.
6.
To check the setting,
seed for approx. 30 m at working speed and then
check the work pattern.
6.4.11.2.2 Adjusting the exact following harrow pressure mechanically
The exact following harrow pressure must be adjusted
such that all seed rows are evenly covered with earth.
On heavy soils, the pressure must be higher than on
light soils.
The exact following harrow pressure is determined by
tension springs, which are attached to a rotating tube.
To adjust the pressure, a stop is pegged onto the
tube. The higher the position of the stop, the greater
the exact following harrow pressure.
CMS-T-00006333-D.1
6 | Preparing the implement
Preparing the implement for operation
MG7508-EN-GB | B.1 | 31.08.2022 | © AMAZONE 73