6
PIX-25
Remove the Cover & Packing Material
1.
Insert the key provided into the keyhole on top of the clock, turn
clockwise ¼ turn to
unlock the cover and
lift the
cover to remove (see
Figure on previous
page).
2.
Remove the
cardboard spacer
located above the
ribbon cartridge by
pulling straight out
(see right-hand
Figure).
3.
Lift up the printer carriage by placing your fingers under the metal motor
on the left-hand side and remove the foam spacer (white) located under
the print head (Figure). Release the printer carriage.
4.
After removing the foam spacer with the cover off
plug in the clock!
Note
–Should the clock not power up, verify that the AC Adapter is
plugged into the rear of the clock.
Note
– If your PIX-25 is located in an area that cannot receive the
Atomic time signal, DO NOT be concerned. The PIX-25 will
accurately keep the time using its Quartz mechanism (plus or minus
three seconds per week).
When you first receive the clock, it may be necessary to adjust the
time so the test printout may not show the accurate time.
: 866-487-4751
VISIT: WWW.TIMECLOCKEXPERTS.COM
