Amano Cleam Mac V-Sigma, Руководство по эксплуатации

Страница: 17 / 40

13
■
Usage Precautions
Observe the following conditions during use. Failure to do so may cause the product to operate at reduced performance or
lead to a failure or an accident.
• This product is intended to be used as an industrial cleaner for collecting and recovering dust. Do not use it for purposes
other than those intended.
• Do not use the cleaner for collecting abrasive particles.
■
Turning the Cleaner ON
Turn the cleaner ON by pressing the OPERATION ON switch.
This will cause the blower motor to start up, activating the vacuum.
Wait at least 7 seconds after the primary power is supplied to the
cleaner before pressing the ON switch. During this time, the
cleaner performs a self-diagnosis (power supply confirmation
and phase detection) and will not turn on even if the switch is
pressed.
The phases of the wires are reversed if the “Power Lamp” blinks
red at 1-second intervals while the blower motor remains
stopped. In this case you must disconnect the power and rewire
the power plug as described in P.14.
■
Turning the Cleaner OFF
1. Press the OPERATION
OFF
switch to shut off the blower
motor.
If your model includes automatic shakeout (models V-2
∑
A,
V-3
∑
A, V-5
∑
A, and V-7
∑
A), it will remain in standby state
for 1 minute after the switch is pressed, and will then shake
out the filter for a period of 10 seconds.
2. Wait for filter shakeout to finish (if applicable), then discon-
nect the plug from the wall outlet.
3. Store the cleaner in a level area where it will be protected
from rain and wind.