Alvarion BreezeACCESS Wi2, Системное руководство

Страница: 162 / 252

140 BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Chapter 8 - Management
8.2.1.1 Attributes
„
System name : Specify a name to identify the AP. Default is the AP’s serial number.
„
Location : Specify a descriptive name for the location where the AP is installed.
„
Contact : Specify information about a contact person for the AP.
„
Community name : Specify the password that controls read/write access to SNMP information.
A network management program must supply this password when attempting to set or get
SNMP information from the AP. By default, this is set to private.
„
Confirm community name : Reenter the Community name.
„
Read-only name : Specify the password that controls read-only access to the SNMP
information. A network management program must supply this password when attempting to
get SNMP information from the AP. By default the Read-only name is public.
„
Confirm read-only name : Reenter the Read-only name.
8.2.1.2 Agent
The SNMP agent is active by default. If you disable the agent the AP will not respond to SNMP
requests.
„
Port: UDP port and protocol the AP uses to respond to SNMP requests. Default port is 161.
„
SNMP Protocol: SNMP version supported. Default is Version 2c which also supports requests
from agents using version 1.
8.2.1.3 Security
Use these settings to control access to the SNMP interface.
„
Allowed addresses : List of IP address from which access to the SNMP interface is permitted.
To add an entry, specify the IP address and appropriate Mask , and then select Add.
„
When the list is empty, access is permitted from any IP address.
„
Active interfaces : Enable the checkboxes that correspond to the interfaces from which to allow
access to the SNMP interface.