Alutech LG-500, Руководство по сборке и эксплуатации

Страница: 68 / 82

ПРИВОД LG-500 | LG-500 DRIVE)
66
ADjUSTMENT
7
Press the button ; after that a dot will appear on the display, which
means the
CLOSED
position.
ATTENTION!
Automatic movement of the door begins immediately
8
The door automatically moves to the
OPEN
position
9
The door automatically moves to the point of contact
10
The door automatically returns to the OPEN position
11
The door automatically returns to the CLOSED position
12
After completion of all positional settings of the door, ‘ F1 ’ inscription will
appear; to exit the setup menu press twice the button or wait for
15 seconds
SETTING P1-F3:
EXPRESS-SETUP OF THE END POSITIONS AND RADIO CONTROL SETUP
The end
OPEN
and
CLOSED
positions are set automatically with a switch to the recording of
remote controls in the programming mode P2 – F1 ( tab . 7).
Y
ATTENTION! Make sure that a support is installed on the rail for the OPEN position ( fig. 16).
1
Simultaneously press and hold the buttons and for ~ 5 secs.
ATTENTION!
Automatic movement of the door begins immediately. Watch
the movement of doors. The automatic setting can be stopped with pressing
any button on the drive panel.
Note: the express-setup procedure can be started similarly, if the mode ‘
P1
’ and
the setting ‘ F3 ’ are selected
2
The door automatically moves to the contact point between the carriage rail
and the support, and a dot appears on the display
3
The door automatically moves to the
CLOSED
position. Movement continues
to the upper panel support, and after that a dot appears on the display
4
The door automatically moves to the
OPEN
position
5
The door automatically moves to the
CLOSED
position
6
‘ rc ’ is shown on the display, which means that the recording of remote controls
in ‘
step
-
by
-
step
’ mode is expected
Table 6