Model:
NettI S
Language:
English
Version:
2020-08
My-Netti.com
25
If the head support stand does not fit
the bracket perfectly the bracket
is probably fixed too tight or unevenly.
After fitting the head support fix it
properly by tightening the little set
screw in the centre on top of the head
support bracket using an Allen key.
If the head support seems to short in
height, it can be turned 180° by
releasing the adjustment wheel at
the rear of the horizontal bar (B) .
6.20 PUSH BOW
Adjustment of push bow:
• Release the red handle on the right side of
the push bow.
• Swing the push bow into required
position.
• Lock the bow in required position by
tightening the red handle.
Be sure to lock the push bow properly.
Make sure the wires for brakes and
tilt/ recline functions never are
sharply bent.
To get the push bow out of the way it
can be turned all the way down till
it touches the chair back.
• The head support bracket is fixed by
tightening the four screws two by two
diagonally so the bracket is fixed with
the same strength divided on the four
screws.
Adjusting the head support in depth:
• Release the locking lever on top of the
vertical bar (A).
• Adjust the head support and fix it in
required position.
Adjusting the head support in height:
• Release the locking lever on the head
support adapter (C).
• Adjust the head support and fix it in
required position.
Adjusting the head support in angle:
• Release the adjustment wheel at the rear
of the horizontal bar (B).
• Adjust the head support and fix it in
required position.
Adjusting the head support sideways:
• The head support adapter can be moved
both to the right and left, giving the
possibility to accommodate special needs
for head support.
• Loosen the four screws holding the
adapter together.
• Move the adapter to the required
position and fix the adapter by
tightening the screws diagonally.
Remember to release the levers
when adjusting the head support.
