Model:
NettI S
Language:
English
Version:
2020-08
My-Netti.com
21
6.17 ADJUSTING ARM SUPPORT
The arm supports are adjusted by:
• opening the arm support lock.
• pull the arm support up or down.
A scale on the vertical profile helps defining
same height on both sides.
The arm pad can be adjusted back- and
forwards by loosening the screws under the
arm pad profile. Push the arm pad to desired
position and fix. On top of the armrest pads
soft armrest cushions can be slipped over.
Remove when a table is mounted.
2 positioning screws allow for limiting
the height. Position them where they are
needed.
6.15 ADJUSTING THE VELCRO
BACK
• Loosen the straps, and place the back
rest cushion so that user gets room for
the bottom and the integrated lumbar
support in correct position.
• Tighten the straps so that they follow the
curvature of the spine and gives a little
extra support at the top of the sacrum.
6.16 SIDE SUPPORT
The back cushion can be sideways stabilized
/ reinforced by mounting side supports.
They are mounted to the chair-back profiles
and can be height and width adjusted to give
the user optimal
side support:
• Fold the back
forwards to a
horizontal position.
• Insert 2 M6
square nuts into
the back profile.
On the lower end
of the profile a
opening allows for
the nuts to enter
into the slot.
• Push the nuts upwards.
• Lay the side support on top of the profile
as shown on the illustration and fix with
screws entering into the 2 square nuts.
• Adjust the height and width of the side
support. Check that the back cushion cover
the side support and leave no hard edges.
