Appendix
111
Administrator Login Failure
If you are unable to perform an Administrator login (because the Username and
Password information has become corrupted, or you have forgotten it, for
example), there is a procedure you can use to clear the login information.
Note:
Performing this procedure also returns all settings to their defaults.
To clear the login information (and return all settings to their defaults), do the
following:
1. Power off the KN9108 / KN9116 and remove its housing.
2. Using a jumper cap, short the jumper on the mainboard labeled J8.
3. Power on the switch.
4. When the front panel LEDs flash, power off the switch.
5. Remove the jumper cap from J8.
6. Close the housing and power on the KN9108 / KN9116.
After powering on the unit, you can use the default Username and
Password (see
, page 15), to log in.
J8
kn9108_9116_2007-09.book Page 111 Friday, September 21, 2007 10:39 AM
