Altigen AltiWare ACM 5.2, Руководство администратора

Страница: 277 / 436

Chapter 22: Workgroup Configuration
AltiWare ACM 5.2 Administration Manual 265
To change Record N out of 10 calls for an agent, click the cell you want to change,
and make a selection from the drop-down list. Click Apply . When finished, click OK .
•
Centralized Recording —You can also enable or disable centralized recording from
the Agent Management Recording window shown above. Click the cell you want to
change, and make a selection from the drop-down list. Click
Apply . When finished,
click OK .
Notes :
–
The recording session starts when the call enters the connected state and ends
when hang up or flash is pressed, or when the call is transferred.
–
The recording setting at Extension Configuration applies only to non-workgroup
calls. The recording setting at Workgroup Configuration applies only to
workgroup calls. To allow an agent to record all calls ( non-workgroup and
workgroup ), both recording settings must be enabled.
–
When an agent logs in to a workgroup, which is also an outbound workgroup, all
outbound calls will be considered as workgroup calls and recorded according to
workgroup configuration.
–
When an agent logs in to a workgroup and is in Not Ready, DND, Wrap-up, or
Inter-call Delay state, outbound calls will be recorded if workgroup recording is
configured.
–
When an agent does not log in to the workgroup that is configured as an outbound
workgroup, all outbound calls are non-workgroup calls.
Establishing Workgroup Membership
Add agent extensions to a workgroup on the Group Member tab in the Workgroup
Configuration window.