Altair Constellation Audio, Руководство пользователя

Страница: 15 / 20

Altair owner’s manual
15
The components will go through a warm-up cycle lasting 1
minute. At the end of this cycle the onscreen buttons for
the components should turn blue. If the Hercules button
instead turns yellow, either one of the Hercules amplifiers
has not been switched on or its AC power has been
disconnected. To correct the problem, return to the
Hercules power screen by tapping the onscreen Hercules
button.
Note also that when Altair is powered-up, the volume level
display in decibels (dB) appears on the Pyxis screen.
When the components are warmed up and ready for
operation, the onscreen buttons for Altair and Hercules are
both blue, the system is warmed up and ready to play.
However, you will hear no sound in this mode because the
units are muted. You can tell when the system is in mute
mode because the small speaker icon in the lower right
corner of the screen has an X next to it.
Check to make sure the volume is not turned up high, then
touch the mute button (the hard button on the far right).
The X will disappear, replaced by two curved lines. The
system is now operational.
If you are using Hercules amplifiers, be especially mindful
to set the volume low before you take the system off mute.
If your source device is emitting a high-level audio signal
and the volume is turned up to full, the extremely high
power output of the Hercules amplifiers can damage your
speakers.