Alpinespas SPA POOL, Руководство пользователя

Страница: 93 / 96

93
TROUBLESHOOTING
Please see our ‘Spa Pool Water Care Handbook’ for a complete guide of
troubleshooting water issues. See page 20 for more information.
General Troubleshooting
Water Troubleshooting
ISSUE POSSIBLE CAUSE SOLUTION
Display is blank Data connection failed Switch Spa pool OFF and ON again
No power Breaker or RCD OFF
Loose plug or wires
Check RCD is turned on
Check plug & wire connections (electrician)
RCD trips Mis-wired connections
Component failure
Check wiring is correct & matches diagram (electrician)
Call for service
Spa pool NOT heating Spa pool in rest/away/sleep mode
Temp set low
Change mode to ready/normal mode
Increase set temperature
Spa pool doesn’t reach
set temperature
Spa pool in rest/away/sleep mode Change mode to ready/normal mode
Low jet pressure Jets closed
2-Speed Pump in low speed
Turn jet face anti-clockwise to open.
Press jet button again to enter high speed
No jet pressure Air-lock in plumbing Prime pump by pressing jets button on/off 2-3 times in
sequence. Bleed pump by loosening the barrel union
Air Blower emits cold air Not a fault, this is normal as air
temperature is colder than water
temperature
N/A
Speakers not
working
Speaker power button is off
Device protection case interfering
Power button sits at the top of the docking station, press to
turn on (see page 86 - 87 for more info)
Remove protective case from device & retry
Spa pool emits high
pitch ringing noise
UV system alarm (bulb has failed) Check for leaking around the UV chamber & replace UV bulb
if necessary.
Spa pool is leaking / wa-
ter appears on ground
around cabinets
Overflow valve engaged
Leaking from barrel union
Leaking from corrosion
Contact Technical Support
Check & tighten barrel unions on pumps & controller
Contact Technical Support