Alpinespas SPA POOL, Руководство пользователя

Страница: 26 / 96

26
Understanding the Display
When the spa pool is first powered and priming has completed, the default display
will show the current water temperature - this is referred to as W.TMP (water
temp). You can cycle between the below three display modes with the ‘UP’ or
‘DOWN’ buttons:
W.TMP
Shows the current water
temperature. This is the
default screen.
Cycle through to next screen
with up/down buttons.
Cycle through to next screen
with up/down buttons.
Cycle through to next screen
with up/down buttons.
S.TMP
Shows the SET water
temperature. Also shows
set temp bottom right.
TIME
Shows the current set time.
The time and date should
be set if not correct.
It’s recommended to leave the display on W.TMP to see a clear difference between
your set temperature and your current water temperature.
Post Heat-up
Once the default 38°C is reached the circulation pump will stop operating and will
only re-engage if the spa pool loses temperature, a filter cycle has begun, or the
system is polling automatically to check temperature.
Changing the Temperature
Pressing or holding the ‘UP’ or ‘DOWN’ buttons will adjust the set temperature in
the direction indicated on the button in increments of 0.2°C. When the LCD stops
flashing, the spa pool will heat to the new set temperature (the spa pool cannot
cool the water).
The ‘PUMP’ button will activate the jet pump and high pressured water will flow
from the jet pieces. The ‘BLOWER’ button will bubble air to the surface of the
water, creating a ‘hot tub/jacuzzi’ type effect.
Testing the Components (Jet Pumps & Blower)
Turn each individual jet piece anti-clockwise to open the flow. Then test the jet
pump(s) and air blower (if equipped) via the topside control panel by pressing:
UP
PUMP
DOWN
BLOWER
6. SPA POOL USAGE GUIDE & TIPS
SPA POOL OPERATION