Alpinespas SPA POOL, Руководство пользователя

Страница: 19 / 96

19
SWITCHING ON & HEATING UP
Automatic Startup Procedure
Upon activating power, the spa pool’s topside control panel should light up and the
screen will display a series of specific sequences and numbers. Reset your spa
pool if the screen is blank.
Priming
The spa pool will enter a ‘priming mode’ whenever it is first initiated or restarted.
This is startup function which will run the circulation pump to clear any air in the
plumbing (priming will finish and exit automatically after 5-10 minutes).
The topside control panel will display “PRIMING” or similar to indicate the priming
mode state.
Check that the circulation pump has engaged by visually sighting moving/rippling
water inside spa pool. Water may flow from the waterfall (if open and equipped).
If the priming function fails, an error message will display on the topside control
panel - check the troubleshooting guide at the back of this manual for assistance.
AVOID PRESSING BUTTONS ON THE TOPSIDE CONTROL PANEL
UNTIL SPA POOL HAS FINISHED HEATING. SPA POOL WILL HEAT
AUTOMATICALLY TO 38
O
C.
HEAT-UP PROCESS
Automatic Heating
After priming has finished, the spa pool is automatically configured to begin
heating to 38
O
C
. The circulation pump will engage and begin filtering and heating
automatically.
Installing the Cover
Place your spa pool cover on top of the spa pool and lock it down by installing the
clips. Full instructions can be found with the clips and screws, which are attached
to one of the 8 hanging cover straps.
Heat Up Time
Depending on environment, it can take up to 12-18 hours to heat the spa pool to
the default 38
O
C
.