Alpha InTec 40GS2, Инструкции по установке и обслуживанию

Страница: 20 / 60

20
Fig. 5.7
5.6 FIT THE FLUE - Figs. 5.5 and 5.6
The following procedure applies to fitting an Alpha CD Easy-Flue to both rear or side exit flue - horizontally only.
1. The CD Easy-Flues are suitable for use in the flue length ranges shown in the tables below.
Note: Where the length is less than the minimum or more than the maximum, refer to Section 5.7.
2. Determine the overall length (L) of flue required, (see Fig. 5.7) as follows:-
Rear flue L = wall thickness (B) + 105 mm
Side flue L = wall thickness (B) + distance between boiler and wall (C) + 145 mm
Alpha InTec 40GS2 - Installation
Fig. 5.5 Fig. 5.6
CD Easy-Flue
500 mm
1000 mm
B (mm)
Max
480
925
Min
255
715
CD Easy-Flue
500 mm
1000 mm
Max
440
885
Min
215
675
B + C (mm)
(B)
Rear Flue
(B + C)
Side Flue
Seal Joint with Tape
L
3. Adjust the telescopic section of the flue to the distance 'L', ensuring that the two labels marked 'TOP' are aligned, then
seal and secure the joint between the ducts with the sealing tape supplied.
Note: Always ensure that there is a minimum overlap of 25 mm when fully extending the telescopic section.
4. Pass the flue assembly through the wall (from inside or outside).
Note: Internal fitting - If there is no access to make good the outside wall, locate the outside (black) flue sealing collar
onto the outer duct of the flue immediately before the terminal grille onto the location provided. Push the flue assembly
through the 130 mm flue hole, so that the collar completely passes through the wall. Then pull the flue assembly back
into the correct position. Visually check that the collar is sealing the outside wall and that it is not restricting any of the
openings of the flue terminal.
All joints between flue sections should be connected using the clamps provided. It is not required to add additional screws
through the clamps and into the flue sections.