Page
36
to
71
Access level selection
This page enables the selection of the access level for the user operating the UPS. If preset, a safety password may
be requested, based on the selected level.
Expand the drop-down menu in the Home page and touch the access level selection icon.
Access level selection page
If some of this icon is not visible, it means that the password protection is not set for this access level.
NOTE:
If no password is configured for a given user-level, the functions relative to that access level are available to
anyone.
Password protection has to be configured from the higher user level.
Access as
“Expert”
user to configure the system.
The drop-down menu in the Home page may change based on the used access level.
When a password protective level is activated a pre-set password permit to access the available command
for that level.
If the display goes in standby (backlight off) the access level will be raised to the higher non password-
protected level.
Password change
Touch one of the three user icons matching the access level for which it is intended to set or change the password
and type/change the password. The password will be required to be entered twice to ensure it is correct.
Entering a blank password will disable the password for that user.
User password configuration page
