Page
33
to
71
Voltage setting
To set the desired output voltage, tap on the corresponding select box. The first selection is customisable by
writing the voltage in the text box. If a low output voltage is selected, the percentage of power derating is shown
on the right.
The modification can be done also when the system is ON LINE.
General configuration page 2: Percentage of power derating with low output voltage.
Frequency setting
To set the desired output frequency, tap on the corresponding select box. Preset frequencies are 50 and 60 Hz.
Custom output frequencies are set by using the service configuration software. If a custom output frequency is
set the value can be read within the text box.
NOTE: The frequency setting is available only when the UPS is in stand-by or the output switch is open.
General configuration page 2: Output frequency configuration.
