Figure 11 Inverter (DE)
Figure 8 Inverter (AU)
INSTALLATION
1.4.3 Inverter Cable Box
1
2
3 4
5
6
7
1 2 3 4
5
6
7
8
Item
Description (DE)
1
2
3
4
5
6
7
8
DC Switch
PV2
PV1
B/-
EMS COM port
On-Grid Wiring Ports
Back Up Wiring Ports
Earthing Point X 2 (Required To Connect With Grounding Copper)
Object
Description (AU)
1
2
3
4
5
6
7
8
PV1
PV2
PV3
B/-
EMS COM port
On-Grid Wiring Ports
Back Up Wiring Ports
Earthing Point X 2 (Required To Connect With Grounding Copper)
1.5 Liability Limitation
2.1 Installation Site and Environment
2.1.1 General
Any product damage or property loss caused by the following conditions AlphaESS
does not assume any direct or indirect liability.
This Manual introduces the basic steps on how to install and set up Alpha ESS
Storion-SMILE-T10
M4856-S is a sealed component with no access to battery terminals or cell components
within module.
• Product modified, design changed or parts replaced without AlphaESS authoriza-
tion;
• Changes, or attempted repairs and erasing of series number or seals by non
AlphaESS technician;
• System design and installation are not in compliance with standards and regula-
tions;
• Failure to comply with the local safety regulations (VDE for DE, SAA for AU);
• Transport damage (including painting scratch caused by rubbing inside packaging
during shipping). A claim should be made directly to shipping or insurance company
in this case as soon as the container/packaging is unloaded and such damage is
identified;
• Failure to follow any/all of the user manual, the installation guide and the mainte-
nance regulations;
• Improper use or misuse of the device;
• Insufficient ventilation of the device;
• The maintenance procedures relating to the product have not been followed to an
acceptable standard;
• Force majeure (violent or stormy weather, lightning, overvoltage, fire etc.);
• Damages caused by any external factors.
INSTALLATION
02
he M4856-S has two versions, one is indoor, and another is outdoor. The SMILE-T10
energy storage system (indoor version) can only be installed in an indoor location. The
SMILE-T10 energy storage system (outdoor version) can be installed in an outdoor or an
indoor location.
The SMILE-T10 systems should be installed in a room, where access to SMILE-T10 is not
obstructed by the structure of the building, fixtures and fittings within the room.
The SMILE-T10 adopts to natural ventilation. The location should be clean, dry and
adequately ventilated. The room’s entry doors and panels shall open in the direction of
egress and allow unobstructed access to the SMILE-T10 for installation and maintenance
purposes.
NOTE:
please pay attention to unpacking the battery, the worst case is that some
components could be damaged.
INTRODUCTION
09
10
