After wiring and EMS setting, check that the status indicators are normal. Then enter
MENU->Status->Communication to check that the communication status of all the
devices are normal.
AC\HYBRID system:
DC system:
Figure 55 Force Charge Start Time
Setting
Figure 56 Force Charge End Time Setting
Step 13
Set the charge start time
Step 15
Set the charging cut-off SOC.
Step 14
Set the charging start time
Figure 57 Charging cut SOC Setting
Figure 58 Discharging cut SOC Setting
Step 16
Set the discharging cut-off SOC.
Step 17
Click Safety in the setting
menu. Set safety standard.
ARN4105 for Germany, CEI0_21 for Italy,
G83_2 for Great Britain, AS4777 for
Australia
Figure 59 Safety Setting Interface
Figure 60 Date&Time Setting Interface
Figure 61 Ethernet interface
Figure 62 Date&Time Setting Interface
Figure 63 Date&Time Setting Interface
Step 21
Make sure all the following
number is correct.
Step 20
Click Language to set language
Figure 64 BMS
Figure 66 BMS
Figure 67 Ethernet and Meter
Figure 65 Ethernet and Meter
Step 18
Click System in the setting
menu. Click Date &Time and set up the
date and time.
Step 19
Click Ethernet to set the IP
address. DHCP mode means that setup IP
address is set up automatically.
If you want to set up the IP address
manually, please choose manual mode.
4.3 EMS Communication Checking
EMS INTRODUCTION AND SET UP
EMS INTRODUCTION AND SET UP
Note:
It is needed to set the following 3 parameters for manual mode:
IP Address: IP address;
Subnet Mask: Subnet mask;
Default Gateway: Default gateway;
Automatic display one parameter:
MAC Address: display MAC Address.
35
36
