ALMAC AlmaCrawler JIBBI 1250 EVO, Перевод оригинальной инструкции

Страница: 199 / 233

PAGE 199 ALMAC s.r.l.
6.4.19.1.2 Checking the fuel lines
ATTENTION:
To avoid personal injury:
•
Only change or check fuel lines after stopping the engine. Defective pipes can cause
fires.
Check the fuel lines every 50 hours of operation. When or if:
1. The clamp is loosened, apply oil to the screw of the clamp and tighten the clamp
securely;
2. The fuel hoses are worn out. Replace them together with the clamps every two years;
3. The fuel pipes and the clamps are worn or damaged before two years, replace or repair
them immediately;
4. After replacing pipes and clamps, purge the fuel system.
IMPORTANT
•
If the fuel hoses are not installed, cover them at both ends with cloth or clean paper to
prevent dirt from entering the pipes. Dirt in the pipes can cause the fuel injection pump
to malfunction.
6.4.19.1.3 Cleaning the fuel filter cup
Every 100 hours of operation, clean the fuel filter. Operation to be performed in a clean place in
order to avoid dust intrusion.
1. Close the fuel filter cup valve;
2. Remove the top cap and rinse the inside with diesel fuel;
3. Remove the element and rinse with diesel;
4. After cleaning, reinstall the fuel filter, protecting it from dust and dirt;
5. Purge the injection pump.
IMPORTANT:
•
The entry of dust and dirt can cause the injection nozzle fuel injection pump to
malfunction. Periodically wash the fuel filter cup.
6.4.19.2 ENGINE OIL
ATTENTION:
To avoid personal injury:
•
Be sure to turn off the engine before checking the oil level and before changing the
oil filter cartridge;
•
Do not touch the muffler or exhaust pipe while they are hot; this could cause serious
burns. Be sure to turn off the engine and allow it to cool before inspecting,
maintaining or cleaning;
•
Contact with engine oil can be harmful to the skin. Wear gloves before using oil. If oil
is spilt on you, wash the part immediately.