Allmand SH-750, Руководство оператора

Страница: 18 / 88

Not for
Reproduction
18
www.allmand.com
Figure 18
A
To shut down the engine
1. Make sure the heater unit has had ample time (5 - 10
minutes) to cool down. See ‘Operating The Heater Unit’.
2. Turn the key switch to the OFF position.
3. Turn the master switch to the OFF position.
Emergency Stop
The emergency stop, located to the right of the control com-
partment access door (left side of the heater trailer), is a
safety device that shuts down the engine and heater trailer in
the event of an emergency. It is to be used only in instances
when the unit must be stopped immediately, such as the
threat of injury, death, or property damage. Do not use as an
alternative to the key switch or master switch.
NOTICE
Use of the emergency stop when the unit is in full operation
could result in equipment damage, as the unit requires ade-
quate time to cool down.
To engage
Press the emergency stop button ( A , Figure 19).
To disengage (reset)
Pull out on the emergency stop button until the button clicks.
NOTE: The unit will not start or operate until the emergency
stop is disengaged.
Pre-Heat System
The heater trailer is equipped with a pre-heat system that
pre-heats the engine coolant, engine oil, and battery prior to
starting.
The pre-heat system should be used at least 30 minutes prior
to starting the engine in temperatures below 32° F (0° C).
To use
Connect a grounded (3 prong) extension cord from the pre-
heat system plug ( B , Figure 19) to an appropriate electric
power source (120 volts AC, 60Hz). Disconnect after starting
the engine.
Figure 19
A
B
Jump Starting The Engine
WARNING
Attempting to jump start or charge a frozen battery could
cause explosion resulting in death or serious injury.
Always be sure that the battery is not frozen, split open or
damaged before attempting to charge or jump start it.
In the event that the battery is insufficiently charged to start
the engine, check the battery to make sure it is not frozen,
split open or damaged. If any of these conditions exist,
replace the battery, and do not attempt to jump start or
recharge it.
If these conditions do not exist, it is permissible to jump start
the engine taking care to follow the proper procedure.
To jump start the engine
WARNING
Allowing the ends of the jumper cables to touch each
other or metal surfaces while connected to a battery could
cause sparks that may ignite battery gases resulting in
death or serious injury. Always keep jumper cable ends
from touching each other or metal surfaces while connect-
ing or disconnecting them.
1. To gain access to the battery, open the engine compart-
ment access door and secure in the locked position. See
‘Compartment Access Doors’.
2. Connect one end of the red jumper cable to the positive
(+) terminal of the booster vehicle battery.