Additional commands may follow an extended-syntax command on the same command line if
a semicolon (";") is inserted after the preceding extended command as a separator. The
semicolon is not necessary when the extended syntax command is the last command on the command
line.
Concatenating Commands after Basic Format Commands
Extended syntax commands may appear on the same command line after a basic syntax
command without a separator, in the same manner as concatenation of basic syntax commands.
2.5 Issuing Commands
All characters in a command line must be issued at the same data rate, and with the
same parity and format.
The modem will ignore any command line that is not properly terminated. The modem may
consider 30 seconds of mark idle time between any two characters as an improperly
terminated command line. In this case the modem may or may not generate an ERROR
message. The modem will ignore any characters received from the DTE that are not part of a
properly-formatted command line.
If the maximum number of characters that the modem can accept in the body is exceeded, an
ERROR result code is generated after the command line is terminated.
The DTE will not begin issuing a subsequent command line until at least one-tenth of a
second has elapsed after receipt of the entire result code issued by the modem in response to
the preceding command line.
2.6 Executing Commands
Upon receipt of the termination character, the modem commences execution of the commands
in the command line in the order received from the DTE. Should execution of a command
result in an error, or a character be not recognized as a valid command, execution is
terminated, the remainder of the command line is ignored, and the ERROR result code is
issued. Otherwise, if all commands execute correctly, only the result code associated with the
last command is issued; result codes for preceding commands are suppressed. If no
commands appear in the command line, the OK result code is issued.
2.6.1 Aborting Commands
Some action commands that require time to execute may be aborted while in progress; these
are explicitly noted in the description of the command. Aborting of commands is
accomplished by the transmission from the DTE to the modem of any character. A single
character is sufficient to abort the command in progress; however, characters transmitted
during the first 125 milliseconds after transmission of the termination character are ignored
(to allow for the DTE to append additional control characters such as line feed after the
command line termination character).
To ensure that the aborting character is recognized
by the modem, it should be sent at the same rate as the preceding command line; the
modem may ignore characters sent at other rates.
When such an aborting event is
recognized by the modem, the modem terminates the command in progress and returns an
appropriate result code to the DTE, as specified for the particular command.
2.6.2 Handling of Invalid Numbers and S-Parameter Values
The modem reacts to undefined numbers and S-parameter values in one of three ways:
1.
Issue the ERROR result code, and leave the previous value of the parameter unchanged;
2.
Issue the OK result code, and leave the previous value of the parameter unchanged; or,
Содержание Tornado 562 S II
Страница 1: ...Tornado 562 S II User Manual...
