Allied Telesis Tornado 562 S II, Руководство пользователя

Страница: 84 / 121

+A8J: - V.8 Negotiation Complete
This indication is issued by either modem when the negotiation is complete and CJ is sent or
detected. An answering modem will issue this on detection of CJ from the remote terminal. A
calling modem will send a CJ signal to the remote terminal at the same time as a +A8J
indication. +A8J:1 indicates CJ; +A8J:0 indicates that the modem timed out waiting for a CJ signal
Indication Syntax
+A8J:<value><CR>
Defined Values
<value> Decimal number corresponding to the selected option.
0 The modem timed out waiting for a CJ signal.
1 CJ signal sent or detected.
Example
+A8J:1 For CJ sent to a remote terminal.
+A8M: - V.8 Menu Report
This indication is issued by either modem, during V.8 negotiation, to indicate the contents of
a valid received CM or JM signal. A +A8M:0 indicates that the modem timed out waiting for
a CM or JM signal.
Report Syntax
+A8M:< hex_string>
Defined Values
< hex_string> CM or JM hexadecimal coded string. A +A8M:0 indicates that the
modem timed out waiting for a CM or JM signal.
Example
A8M:XXX YYY
+A8R: - V.8bis Signal and Message Reporting
If enabled by +A8E=,,,[<v8b>=2] command, the modem monitors for V.8 bis signals and
messages, and uses the +A8R: intermediate result code response to report that signal. Two
concatenated V.8
bis messages are reported with two consecutive <message> indications.
Report Syntax
+A8R:<signal>[,[<1st message>]][,<2nd message>]<CR>
Defined Values
<signal> The V.8 bis signal, if detected, is indicated using a <signal> value
(see Table 3-3). Values of 4 and 8 are not reported, i.e., the modem
is not expected to discern the power level of received CRe and
MRd signals. If a V.8
bis message is detected without a preceding
V.8 bis signal, the preamble is reported as a 0 <signal> value.
<1st message> The contents of valid V.8 bis message(s), if detected, are reported
using hexadecimal octet coded string(s) (A.4.1). Flag detection and
consumption, flag transparency 0-bit deletion and FCS checking
are performed by the modem. The modem does not report invalid
messages (e.g., bad FCS). If two consecutive messages are
detected but the first is invalid, the modem indicates this with no
characters between the first and second comma (e.g.,
+A8R:<signal>,,<2nd message>).
<2nd message See <1st message>.
Example
+A8R:0,XX,YY For a V.8 bis message detected without a preceding V.8 bis signal.
+A8R:0,XX,YY For a V.8 bis message detected with a preceding V.8 bis signal.