Allied Telesis Tornado 562 S II, Руководство пользователя

Страница: 109 / 121

+FTS=<time>
Defined Values
<time> Decimal number from 0 (default) to 255 which specifies the length
of time in 10-ms intervals to delay before responding with the OK
result code after terminating the session.
Result Codes
OK Reported when transmission has been terminated for the specified
amount of time.
ERROR <value> is invalid or this command is issued while the modem is on-hook.
Reporting Supported Range of Parameter Values
Command: +FTS=?
Response: +FTS: <time> range
Example: +FTS: 0-255
+FRS - Receive Silence
This command causes the modem to listen and report an OK result code when silence has
been detected on the line for the specified period of time. This command will terminate when
the required period of silence is detected or when the DTE sends the modem another character
other than XON or XOFF, which is discarded. In either event, the OK result code is returned.
This command is aborted if any character is received from the DTE after receipt of the
command but before the time delay elapses. In this case, the modem discards the aborting
character and issues an OK result code.
Syntax
+FRS =<time>
Defined Values
<time> Decimal number from 0 (default) to 255 which specifies the length
of time in 10-ms intervals to delay before responding with the OK
result code after detecting silence on the line.
Result Codes
OK Reported when silence has been present on the line for the
specified amount of time or when the DTE sends the modem a
character other than XON or XOFF.
ERROR <value> is invalid or this command is issued while the modem is on-hook.
Reporting Supported Range of Parameter Values
Command: +FRS=?
Response: +FRS: <time> range
Example: +FRS: 0-255
+FTM - Transmit Facsimile
This command causes the modem to transmit data using the modulation defined below. When
a valid <mod> value is entered, the modem transmits the proper training sequence in the
selected mode, followed by constant 1 bits until data is received from the DTE. The modem
also returns the CONNECT result code at the beginning of the training sequence.
Syntax
+FTM=<mod>
Defined Values
<mod> Decimal number corresponding to the selected modulation mode
and data rates shown in Table 4-2.
Table 4-2. Fax Class 1 and Fax Class 1.0 Modulation Modes and Rates
<mod> Modulation Training Modulation Mode and Rate
3 V.21 300 bps
24 V.27 ter 2400 bps
48 V.27 ter 4800 bps