TFTP
96
Put
A TFTP configuration field “put” file involves the use of any, or all,
configuration parameters.
To download the image file for an AT-4016TR, AT-4016F, or AT-TS95TR
respectively:
tftp put image.s13 (IP address) AT4016 octet (or)
tftp put image.s14 (IP address) AT4016 octet
tftp put image.s16 (IP address) ATTS95 octet
Once the file is placed on the switch, downloading procedures are initiated.
The switch responds to a TFTP ‘put’ request by accepting program data from
the sending host. The system will write the new program image into its non-
volatile memory. When the TFTP session is complete, the system will reboot
itself and begin executing the new program.
NOTE
The switch will not accept a TFTP “put” request if a PCMCIA card or
Firmware Cassette is installed.
When you use TFTP, the file name for the switch must be the same as the
downloaded password. For example, if you had changed the default download
password to ALLIED, and the configuration file on your PC was
NEWCONF, your TFTP command line might look like the following:
TFTP PUT NEWCONF 135.24.35.122 ALLIED ASCII
General System Configuration
Description
FIELD IDENTIFIER and VALUEs
Terminal Baud Rate:
BAUD = 19200
Allowable configuration data:
AUTO, 192000, 9600, 4800, 2400, 1200, 600, 300,
150, 75
Default Value:
AUTO
Terminal Data Bits :
DATA BITS = 8 BITS
Allowable configuration data :
7 BITS, 8 BITS
Default Value :
8 BITS
Terminal Stop Bits :
STOP BITS = 1 BIT
Allowable configuration data :
1 BIT, 2 BITS
Default Value :
1 BIT
