Allied Data Technologies CopperJet 416, Руководство по установке

Страница: 38 / 51

Chapter 6.2: Advanced Voice over DSL Configuration
Page 36
Global IP Address: If you are mapping from a global IP address, type the
address here. If you are mapping from a security
interface, type 0.0.0.0.
Internal IP Address: The IP address of an individual host inside your
network.
Transport Type:
Specify the transport type that you want to map from
the outside interface to the inside.
Port Number:
The port number that your transport uses.
Once you have configured the table, click on Add reserved mapping. The table is
refreshed and the reserved mapping is added to your NAT configuration.
Important:
Make sure the Internal IP address is in the same subnet as your
CopperJet LAN IP address.
To delete a reserved mapping, click on the Delete hyperlink. The Delete
Reserved Mapping Confirmation page is displayed. Click on the Delete Reserved
Mapping button. The reserved mapping is deleted.
Don’t forget to save the changes. Go to the Configuration menu and click on Save
config to save the new settings into the CopperJet.
5.6.4 Enabling Firewall
Before enabling the firewall, you must have Security enabled and you must have
at least 1 internal interface or 1 external interface configured. Be sure that
the WAN and/or LAN connection and the Security Interfaces are defined and
configured.
To enable the Firewall go to the Security State section and select Firewall
Enabled. Click on Change State to update the Security State section. The Firewall
is now enabled on the CopperJet.
Important:
Enabling the Firewall will block ALL traffic going in and out of the
CopperJet. Firewall Policies need to be configured for allowing traffic to
pass through.
5.6.5 Enabling Intrusion Detection
Before enabling Intrusion Detection, you must have Security enabled and you
must have at least 1 internal interface or 1 external interface configured. Be
sure that the WAN and/or LAN connections and the Security Interfaces are
defined and configured.
To enable Intrusion Detection, go to the Security State section and select
Intrusion Detection Enabled. Click on Change State to update the Security State
section. The Intrusion Detection is now enabled on the CopperJet.