TIMING
Your system automatically switches off after running for 20 minutes. This is the recommended time for getting the most out of your bath.
AUTOMATIC DRYING
Your bathtub is fitted with an automatic drying system.
When you empty your bathtub and the water level detector finds no more water in the bath, the AIR massage indicator light flashes
indicating that the drying programme is now running.
Ten minutes elapse before the drying cycle kicks into action. We advise you to make good use of this time to perform the daily upkeep of your
bathtub. When the 10 minutes are up, the blower automatically starts up again and runs for 5 minutes. This dries out the air pipes in your
bathtub.
MANUAL DRYING
After a shower or after cleaning your bathtub, you can start up the automatic drying fuction manually to eliminate any water remaining in the
air injectors.
Press the AIR button and hold it in for 5 seconds to set the function going.
The AIR button indicator light will flash and the blower will start up after 10 minutes then run for 5 minutes.
IMPORTANT
- Before starting up the ALLIBERT system, make sure there is water covering all the jets so as to avoid getting sprayed.
- Never use products that produce foam; their effect is exacerbated by the water turbulence
- Never use products such as mud, seaweed, or clay; these might clog the injectors.
WATER MASSAGE
o Pressing this button once starts up the pump and the indicator light above the
button comes on.
o Pressing it again stops the pump.
AUTOMATIC "PULSE" PROGRAMME
o Pressing this button once starts up the automatic PULSE programme with the
pump (the indicator light above the button comes on). This programme runs for
15 minutes maximum.
o Pressing again stops the automatic programme..
AUTOMATIC "WAVE" PROGRAMME
o Pressing this button once starts up the automatic WAVE programme with the
blower (the indicator light above the button comes on). This programme runs for
15 minutes maximum.
o Pressing again stops the automatic programme.
AIR MASSAGE
o Pressing this button once starts up the blower at 50% power and the indicator
light above the button comes on.
o Pressing again stops the blower.
CHROMO MINI SPOTLIGHT, 8 colours
o Press this button once to start the CHROMO spotlight.
o Press again to switch to STOP COLOUR mode. The spotlight stops on the
current colour.
o Press again to switch off the STOP COLOUR mode.
AIR MASSAGE POWER
o Pressing this button and holding it down lets you reduce blower power down
to 10%
o Pressing and holding it down again lets you raise blower power to 100%
USE
WATER MASSAGE
o Pressing this button once starts up the pump at 50% power and the indicator light
above the button comes on.
o Pressing it again stops the pump.
o Pressing this button and holding it down lets you reduce the pump down to 10%
o Pressing and holding it down again lets you raise the pump power to 100%
AIR MASSAGE
o Pressing this button once starts up the blower at 50% power and the indicator light above
the button comes on.
o Pressing again stops the blower.
o Pressing this button and holding it down lets you reduce blower power down to 10%
o Pressing and holding it down again lets you raise blower power to 100%
DRAINING/ZONING MASSAGE
o Pressing this button once starts up the AIR draining mode (the indicator light above the
button comes on). The AIR massage zones are changed around every 4 seconds.
o Pressing again starts up the zoning mode, stopping at the zone in progress (the indicator
light above the button flashes).
o Pressing again after the zoning mode returns the system to the draining mode.
To exit draining or zoning mode, press the AIR massage button.
AUTOMATIC "TONING" PROGRAMME
o Pressing this button once starts up the automatic TONING programme (the indicator
light above the button comes on). This programme runs for 10 minutes maximum.
o Pressing again stops the automatic programme.
AUTOMATIC "RELAX" PROGRAMME
o Pressing this button once starts up the automatic RELAX programme (the indicator light
above the button comes on). This programme runs for 15 minutes maximum.
o Pressing again stops the automatic programme.
BALNEO
CONTROL
PAD INTENSEA
BALNEO
CONTROL
PAD DOLCEA
CHROMO MINI SPOTLIGHT, 8 colours (Non functional if presence of the option music)
o Press this button once to start the CHROMO spotlight.
o Press again to switch to STOP COLOUR mode. The spotlight stops on the current
colour.
o Press again to switch off the STOP COLOUR mode.
DESCRIPTION OF FUNCTIONS
This system gives you the choice between an invigorating massage produced by water under pressure and a relaxing bath
produced by air bubbles, or you can combine the two, all at your chosen intensity.
Start-up and access to the various functions is by means of a control pad linked to an electronic control box. A pump sends the water
into the side and back jets, producing a toning massage. A turbine propels air into the injectors laid out around the bottom of the bath
to produce a more relaxing massage
GB
