ALLIANCE ZWN43RSN115CW01, Инструкция по эксплуатации

Страница: 16 / 36

Error Codes
Status lights may flash or remain on continuously to indicate an
error condition. The number of flashes listed below is followed
by a pause. Then the flash sequence will repeat.
Display Description Cause/Corrective Action
WASH, RINSE 1
time Pressure Sensor Error Check for broken wires or bad connection on Pressure Sensor
Harness.
WASH, RINSE 2
times Fill Error Check for low water pressure, clog in line or plugged fill hose
filter screens.
WASH, RINSE 2
times No Water Flow Error Pressure sensor hose is broken or disconnected. Check for no
water lines connected, no water pressure, or clog in fill hose and
filter screens.
WASH, RINSE 3
times Suds Lock Error Check for too much soap in machine (use less soap), clogged
drain, stuck pump, item stuck outside of washtub and possibly
between washtub and outer tub.
WASH, RINSE 4
times Slow Drain Error Draining took longer than expected. Check for clogs and for ex-
cessive amount of soap used.
WASH, RINSE con-
tinuous Water Leak Error Machine is leaking water due to leaking water valves, a hole in
machine, or disconnected drain hose.
WASH, RINSE con-
tinuous Overflow Error Check for leaking water valves allowing water to come into ma-
chine. Check for debris in water valves. Check that water pres-
sure is the same on both hot and cold lines and is within spec.
WASH, RINSE con-
tinuous Drain Error Check for clogged drain or clogged pump. Make sure drain hose
is not too tall. If pump is overheating, frequency/voltage on ma-
chine/pump do not match.
RINSE, LID LOCK
2 times Non Fatal Lid Locking Error Check if lock is wet. Allow to dry. Check lid lock alignment.
Check for broken wiring to lid lock or broken lid hook. Load/
pressure on lid needs to adjusted.
RINSE, LID LOCK
2 times Fatal Lid Lock Error The control senses that the lid has unlocked during a running cy-
cle. Check lock and wiring. If lock is wet, allow to dry. Unplug
machine to clear this code.
RINSE, LID LOCK
3 times Lid Open Error Lid was sensed open during a running cycle. Check lid switch
and wiring.
RINSE, LID LOCK
3 times Non Fatal Lid Unlocking Error Check if lock is wet. Allow to dry. Check lid lock alignment.
Check for broken wiring to lid lock or broken lid hook. Load/
pressure on lid needs to adjusted.
WASH, SPIN, LID
LOCK 2 times Broken Belt Error Drive belt is sensed as broken or has fallen off. Replace belt. If
belt is not broken, replace front end control.
Table 10 continues...
Error Codes
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
16 Part No. 204666ENR1