ALLIANCE BTEBCFSP171TW01 BTEBEFSP171TW01, Руководство по устранению неисправностей

Страница: 114 / 117

112
802748
Dryer Test Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
61. Sensor Check (Gas Models)
a. While supporting the access panel, remove
two screws from bottom edge of access panel.
b. Gently lower the access panel to disengage
locators from bottom edge of front panel.
c. Close main gas shut-off valve. Refer to
Figure 19 .
d. Remove wires from sensor terminals.
e. Set test meter to read Ohms and put meter
probes on sensor terminals. Meter should read
“zero” Ohms. If meter registers an Ohm
reading of any amount, replace sensor.
62. Igniter Check (Gas Models)
a. While supporting the access panel, remove
two screws from bottom edge of access panel.
b. Gently lower the access panel to disengage
locators from bottom edge of front panel.
c. Close main gas shut-off valve. Refer to
Figure 19 .
d. Disconnect igniter wires at disconnect block.
e. Set test meter to read Ohms and put meter
probes on terminals of igniter wires.
f. Silicon Carbide Igniter – meter should read
between 45 – 200 Ohms. Refer to Figure 38 .
NOTE: If meter does not read appropriate Ohms,
then replace the igniter.
IMPORTANT: Always examine all wires, terminals
and connectors to be sure wiring is correct before
replacing any components.
Figure 38
SILICON CARBIDE IGNITER AND
BRACKET ASSEMBLY
D337SE3A
Igniter and
Bracket
Attaching
Screw
White
Ceramic
Portion