Alliance Laundry Systems SGHP190E, Руководство по программированию

Страница: 14 / 57

• Each step always consists of a Dry sequence and a Cooldown
sequence.
• You will notice that each step has default settings. This fea-
ture is very helpful as most of the newly created programs
will not require changes to be made to the suggested values.
Programming the Dryer sequence :
• First set the target temperature.
• Then set the Dry time or Humidity (only applies to machines
fitted with a humidity sensor).
Programming the Cooldown sequence :
• After programming the Dry sequence, next program the Cool-
down sequence.
• Set the parameter to stop the Cooldown sequence : Time or
Temperature
• As you will notice it’s also possible to skip a sequence be-
tween two other sequences by programming a time value =
0. )
The Anti-Wrinkle sequence :
• To avoid Wrinkling, its recommended that the linen is re-
versed each 2 to 10 minutes once the drying cycle has finish-
ed and the machine is not unloaded. A beep signal warns the
operator that the cycle has been finished.
WARNING
A MORE DETAILED EXPLANATION FOR THE SPE-
CIFIC SEQUENCES CAN BE FOUND IN CHAPTER
PROGRAMMING.
C105
The Final Cooldown sequence :
• To avoid that the linen stays in the dryer with a too high tem-
perature, for safety purposes, a Final Cooldown sequence is
added at the end of the program.
• The Final Cooldown sequence takes 3 minutes if the tempera-
ture is above 50 °C, then the program is finished.
• The Final Cooldown sequence cannot be changed.
Programming the Functions
Limits:
• To ensure the correct functionality of the dryer you have to
program values within certain limits.
• If you program a value that falls below the minimal or above
the maximal programmable limit then the new value will not
be accepted and the previous value stays valid.
Programming the Dry Temperature
• Limits:
• Dry Temperature : 1 - 70 °C
Programming the Dry Time
• Limits:
• Dry Time : 0 – 120 Minutes
Programming the Cooldown Time
• Limits:
• Cooldown Time : 0 – 120 Minutes
Programming the Cooldown Temperature
• Limits:
• Cooldown Temperature : 1 - 70 °C
Programming the Motor On and Off times for Reversing
• The standard Reversing Motor On and Off times are 40 Sec-
onds On and 5 Seconds Off.
• Limits:
• Reversing motor on Off times : 3 – 300 Seconds
Programming the anti-wrinkle sequence
• The drum is turning each 2 to 10 minutes for 5 seconds for a
max programmable time of 3 hours.
• A buzzer is beeping when the drum turns.
• Limits:
• Action time Drum : 3 – 180 seconds
• Interval time Drum at rest: 1 – 15 minutes
• Anti-wrinkle time : 15 – 180 minutes
Basic Description of Controls
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
14 Part No. D1621ENR3