56
800793
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
IMPORTANT: Always replace seal with a new seal.
Spray or apply a mixture of diluted laundry
detergent to assist in installation of new seal. The
“puffy” side of seal should be installed to the inside.
For best results, tap clamp ring all around while
tightening screw and nut.
NOTE: Install metal clamp ring by placing clamp
ring opening at approximately the 10 o’clock
position to ensure that no interference is
encountered with side panel or the underside of the
cabinet top. Tighten the clamp ring screw and nut
until a spacing of one inch is achieved at the clamp
ring opening or until tight.
Figure 21
FLW1116S
CLAMP
RING
SCREW
SEAL
OUTER TUB
FRONT PANEL
GROUND
WIRE
WASHERS
NUT
