800793
39
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
16. TEMPERATURE SWITCH
a. Remove three screws holding rear of hood
assembly to control hood rear panel. Refer to
Figure 5.
b. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
c. Disconnect wires from switch terminals.
NOTE: Refer to wiring diagram when rewiring
switch.
d. Refer to Figure 6 for switch removal.
e. Press in on two locking tabs and at the same
time turn switch 1/4 turn counterclockwise to
remove switch from switch bracket. Refer to
Figure 6.
IMPORTANT: Before removing switch, note
switch position in relation to switch bracket so
switch can be reinstalled in same position.
NOTE: When installing switch, place switch tabs
into cutout in switch bracket and turn switch
clockwise to its full limit of travel, within the switch
bracket opening, until both locking tabs snap into
place.
17. PRESSURE SWITCH
a. Remove three screws holding rear of hood
assembly to control hood rear panel. Refer to
Figure 5.
b. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
c. Disconnect wires from pressure switch. Refer
to wiring diagram when rewiring switch.
d. Refer to Figure 6 for switch removal.
IMPORTANT: Before connecting hose to pressure
switch, blow air through pressure hose to remove
any condensation that may have accumulated in
hose.
18. EXTRA RINSE SWITCH
a. Remove three screws holding rear of hood
assembly to control hood rear panel. Refer to
Figure 5.
b. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
c. Carefully remove bottom front of hood from
clips on cabinet top.
d. Disconnect wires from switch terminals.
NOTE: Refer to wiring diagram when rewiring
switch.
e. Remove extra rinse switch by pressing in on
locking tabs and pushing switch out through
front of graphic panel. Refer to Figure 6.
19. CONTROL RELAY
a. Remove three screws holding rear of hood
assembly to control hood rear panel. Refer to
Figure 5.
b. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
c. Disconnect wires from the control relay.
NOTE: Refer to wiring diagram when rewiring
control relay.
d. Remove two screws holding relay to control
hood rear panel. Refer to Figure 6.
