800793
35
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 5
Service Procedures
IMPORTANT: When reference is made to
directions (right or left) in this manual, it is from
operator’s position facing front of washer.
14. CONTROL HOOD ASSEMBLY
a. Remove three screws holding rear of hood
assembly to control hood rear panel. Refer to
Figure 5.
b. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
c. Carefully remove bottom front of hood from
clips on cabinet top.
d. Disconnect wires from components and
carefully remove components from hood
assembly.
NOTE: Refer to wiring diagram when rewiring
component parts.
TO REMOVE CONTROL HOOD END
PANELS
Remove two screws holding each end panel to
control mounting plate. Refer to Figure 6.
Figure 5
W169SE3B
HOOD
ATTACHING
SCREWS
W252IE1A
PIVOT
HOOD
FORWARD
