40
800793
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
20. MOTOR CONTROL BOARD
a. Remove three screws holding rear of hood
assembly to control hood rear panel. Refer to
Figure 5.
b. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
c. Disconnect harness connectors from control
board.
NOTE: Refer to wiring diagram when rewiring
control board.
IMPORTANT: Remove control board and metal
mounting plate as a unit. Handle control board by
the back metal plate. Do not contact control board
with hands or metal objects. Place assembly in
clean, dry area away from work area to avoid
damage. Do not attempt field repair of the motor
control board. Attempted repair or tampering with
the control board will void its warranty.
d. Remove four screws holding motor control
board to control hood rear panel. Refer to
Figure 6.
e. Remove control board and place in anti-static
shipping material for return to manufacturer.
IMPORTANT: It is important to take care when
handling original control. It must be carefully
placed in anti-static shipping material which was
removed from new control. Warranty credit will
not be issued if control is not wrapped properly.
21. SIGNAL CONTROL
a. Remove three screws holding rear of hood
assembly to control hood rear panel. Refer to
Figure 5.
b. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
c. Carefully remove bottom front of hood from
clips on cabinet top.
d. Disconnect wires from signal control terminals.
NOTE: Refer to wiring diagram when rewiring
signal control.
e. Remove control knob from switch shaft.
f. Remove two screws holding signal control to
control mounting plate. Refer to Figure 6.
22. DOOR LOCK INDICATOR LIGHT
a. Remove three screws holding rear of hood
assembly to control hood rear panel. Refer to
Figure 5.
b. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
c. Carefully remove bottom front of hood from
clips on cabinet top.
d. Disconnect two wires from door lock indicator
light.
NOTE: Refer to wiring diagram when rewiring
light.
e. Refer to Figure 6 for light removal.
