11
503806
7.
While supporting lower access panel, remove two screws from bottom
edge. Gently lower access panel to disengage guide lugs from bottom
edge of front panel.
8.
Remove two screws holding bottom tabs on front panel to dryer cabinet.
Swing bottom of front panel away from dryer far enough to disengage
hold-down clips and guide lugs from cabinet top.
9.
Disconnect wires from door switch.
NOTE: Refer to wiring diagram when rewiring switch.
10. Remove two cabinet top hold-down screws and install two #10 tamper-
resistant screws, Part No. 62853.
11. Reinstall door switch, front panel and install two #10 tamper-resistant
screws, Part No. 62853 to secure lower access panel.
NOTE: Tamper-resistant bits and bit holder, for installation of tamper-
resistant screws, are available as optional equipment at extra cost.
•
Bit (#8 screws) ................ Part No. 281P4
•
Bit (#10 screws) ............... Part No. 282P4
•
Bit Holder (3/8 drive) ....... Part No. 24161
D237IE2B
HOLE
#8 SCREWS
35528
#10 SCREWS
62853
#10 SCREWS
62853
