Allen-Bradley 2094-AL09, Руководство по установке

Страница: 33 / 60

Rockwell Automation Publication 2094-IN005H-EN-P - October 2012
Line Interface Module 33
Wiring Guidelines
Use these guidelines as a reference when wiring the connectors on your line
interface module.
See Wiring Diagrams beginning on page 43 for interconnect diagrams including
the line interface module.
Follow these steps when wiring the connectors on your line interface module.
1.
Prepare the wires for attachment to each connector plug by removing
insulation equal to the recommended strip length.
2.
Route the cable/wires to your line interface module.
3.
Insert wires into connector plugs.
See connector pinout tables beginning on page 11 .
4.
Tighten the connector screws.
5.
Gently pull on each wire to make sure it does not come out of its terminal.
If any wires are loose, then repeat steps 3 and 4.
6.
Insert the connector plug into the appropriate connector.
IMPORTANT
See Connector Data on page 9 for the connector locations of your line interface
module.
When tightening screws to secure the wires, see the tables beginning on page 31 for
torque values.
When removing insulation from wires, see the tables beginning on page 31 for strip
lengths.
IMPORTANT
To ensure system performance, run wires and cables in wireways as shown in
Establishing Noise Zones on page 6 .
IMPORTANT
Use caution not to nick, cut, or otherwise damage strands as you remove the
insulation.