HERA LS Series CD/DVD Duplication System / User Manual
23
Duplicator B.30
1. Copy (MM)
Preparing...
Please Wait
Loader Processing
Drive 1 <- Input Bin
Processing...
Please Wait
Loading... RESERVED
36% 121MB Loaded
Loader Processing
Drive 1 <- Input Bin
Input Bin Empty (20)
Press OK to Continue
Loader Processing
Drive 1 -> Output Bin
The blank discs for the third job
etc.
If your autoloader has more than one Input Spindle, then the job sequence can be spread across the spindles, in
sequence. CD duplication jobs and DVD duplication jobs can be intermixed. The autoloader will automatically
detect a job’s master and blank disc format and copy them when they match.
You should still be at the
1. Copy
Menu:
Press the
Enter
button to start the duplication job.
After a short interval, the robotic loader will pick the top disc (master disc) from
the Input Spindle and place it into one of the drives. As this is happening, you will
see a screen similar to below:
This information screen shows what is happening. In this case, the loader has
taken a disc from the Input Spindle and is placing it into Drive 1.
The loader will continue to remove discs from the Input Spindle and place those
into drives until either all of the drives are full or all Input Spindles are empty.
It takes a few seconds for the autoloader to recognize all of the discs in the trays.
Once all of the discs are detected, the autoloader will detect the master disc
and read the contents of the master disc into the reserve partition.
Once the master disc has
been loaded, the autoloader will remove
the master disc from the drive
and place it onto the Output Spindle.
The loader will then pick up another blank disc and load it into the drive where
the last master disc was placed.
Once the loading process is completed, the duplication process will start. When the duplication process is through,
the loader will remove the discs from the drives and place successful copies onto the Output Spindles and place
failed copies onto Rejected Area.
In Multi Master Mode, the robotic arm continues to load more media into the drives from Input Spindles while the
duplicated discs are placed in the Output Spindle. Once a new Master disc are been detected by any of the drives,
this process will repeat for the new Master disc.
When all of the jobs are complete, and the autoloader detects all Input Spindles are empty, it presents you with the
Input Bin Empty message:
Press the
Enter
button to continue and you will see the
Access Log File
screen:
