ALIBI ALI-PTZ23X, Руководство пользователя

Страница: 45 / 96

37 HD-TVI 23x Zoom PTZ Camera User Manual
PRELIMINARY
SECTION 4: CONFIGURING THE PTZ CAMERA
To change a parameter value:
2.
Use the p and q buttons to move the position icon to the parameter you want to change, and then click
Iris+
. The
position icon will change to a .
NOTE
: If the position icon is before SYS TIME or DISPLAY SETTINGS, a submenu will open.
See below.
3. Use the p and q buttons to show the parameter to what you prefer.
4. Click
Iris+
again to change the parameter. The position icon will change to either a , or .
5. Repeat steps
1
through
3
above to change other parameters, if needed. See the list below.
Parameters include:
•
SOFT ADDR ACTIVE : If the SOFT ADDR ACTIVE is set ON, the soft address is the valid address for connecting the camera. The
SOFT ADDRESS ranges from 1 to 255. If the SOFT ADDR ACTIVE is set as OFF, the hard address set by the DIP switch is the
valid address of the camera.
•
BROADCAST ADDRESS : When the BROADCAST ADDRESS is set to ON, the control devices with address 0 can control the
camera remotely regardless of the address of the camera. This function is usually used for debugging.
•
SOFT BAUD ACTIVE : If the SOFT BAUD ACTIVE is set to ON, the soft baud rate is the valid baud rate for the camera. You can
select either 2400, 4800, 9600 or 19200. If the
SOFT BAUD ACTIVE
is set to OFF, the baud rate is set by the hardware DIP
switches.
•
PELCO CHECKSUM
: If the camera uses PELCO-P or PELCO-D protocol, you can set the PELCO CHECKSUM to ON to improve the
video quality.
•
EIS
(Electronic Image Stabilization)
FUNCTION
: You can set the
EIS FUNCTION
to ON or OFF.
•
FAN CONTROL
: You can set the internal
FAN CONTROL
to TEMP, ON or OFF. When FAN CONTROL is set to TEMP, the fan is
controlled by the temperature.
•
PRESET
(direct focus): You can set the preset direct focus function to ON or OFF.
•
PROTOCOL
: You can set this option to AUTO MATCH, PELCO-P, PELCO-D, Private-code, etc.
•
PROTOCOL - C (PELCO COAXITRON): Controls RS-485 features through coax.
•
PROTOCOL STATUS SET : You can set this option to ON or OFF. When set to ON, you can control the camera with user-defined
protocols.
•
485CHECK SET : You can set this option to ON or AUTO to improve the controlling effect. . Need an explanation here.
•
POWER MEMORY : The camera can resume its previous PTZ status after it restarted from a power-off when it stops at a
position longer than the predefined time. You can set the memory time to 10S, 30S, 60S, 180S, and
•
300S.
•
NEAR FOCUS LEVEL : You can set this option to ...... Need an explanation here.
•
COAXITRON ACTIVE : You can set this option to ...... Need an explanation here.
4.6.1 Setting SYStem TIME
1. Open the SYS TIME submenu from the OSD MAIN MENUS | DOME SETTINGS | SYS INFO SETTINGS menu.