Alfresco ALSB-2, Инструкция по уходу и эксплуатации

Страница: 8 / 20

8
LP GAS CONNECTION TO LP TANKS:
Your ALFRESCO™ Side Burner for use with LP gas comes equipped with its own regulator, which
MUST NOT be removed. There is also a secondary high capacity, hose/regulator assembly for
connection to a standard 20 Lb. LP cylinder. The LP gas pressure regulator and hose supplied with this
unit must be used without alteration.
If this assembly needs to be replaced use only the type specified by ALFRESCO™ for this appliance.
To connect the regulator / hose assembly follow the next steps:
•
Locate the regulator and gas connection point in the rear side of your
Side Burner unit .
•
Verify that the a 1/2” FPT x 1/2” MPT (male-to-female) connected to
the regulator points in the required direction. (see Figure # 2)
•
Fasten the hose connection to a 1/2” MPT x 3/8” COMP
(compression flare fitting) connected to the elbow. (see Figure # 2).
LP GAS CONNECTION TO LP PIPED SYSTEMS:
An LP piped system is one with a large central LP tank that feeds the entire household. Those systems
are normally equipped with a high pressure regulator by the large LP tank and low pressure regulators
close to the home.
WARNING
ENSURE THAT THE GAS
SUPPLY HOSE DOES NOT
COME IN CONTACT WITH
THE SIDE BURNER BODY
CONVERTIBLE GAS
PRESSURE REGULATOR
Figure # 2
SIDE BURNER UNIT
(COUNTER MOUNT)
1/2” FPT X 3/8” FLARE
BRASS FITTING
1/2” FPT X 1/2” MPT
90° ELBOW
TYPICAL LP
GAS TANK
LP REGULATOR AND HOSE
ASSEMBLY (PRESET TO 10” WC)