Alfresco ALSB-2, Инструкция по уходу и эксплуатации

Страница: 6 / 20

6
LOCATING AND ASSEMBLING THE SIDE BURNER:
When determining a suitable location for your Side Burner, take into account concerns such as exposure
to wind, rain, sprinklers, proximity to traffic paths and keeping any gas supply line runs as short as
possible.
Locate the Side Burner only in a well-ventilated area. Never locate the Side Burner in a building, garage,
breezeway, shed or other such enclosed areas without an approved ventilation system. Never locate
the Side Burner over, under or next to unprotected combustible construction.
CLEARANCES:
TO NON-COMBUSTIBLE CONSTRUCTIONS:
A minimum of 3” clearance around the Side Burner to non-combustible construction is required to allow
heat to escape freely while cooking.
TO COMBUSTIBLE CONSTRUCTIONS:
This appliance should NOT be located over, under or next to unprotected combustible construction.
ASSEMBLY:
BUILT-IN MODELS:
To locate your ALFRESCO™ Side Burner into your Non-combustible enclosure, complete the following
steps:
1. Remove all packaging materials
2. Install and secure the body of the Side Burner to your counter’s enclosure.
3. Ensure that the burners are positioned correctly on their venturi funnels, and are fully
seated onto their supports. (See figure # 1)
4. Install the Side Burner Grate.
5. Make the connection to the gas regulator according to the instructions on pages 8 & 9 for
your gas type.
6. To comply with safety and service requirements, main gas shut off valve must be
accessible from front of Side burner without using any tools.
CART MODELS:
Please follow the instructions supplied with the unit in order to mount and connect all required piping that
comes with the unit.
WARNING:
To prevent harm and ensure proper operation of your Side Burner, it is imperative that the burners are
properly installed with respect to the gas orifices. Be certain that the exterior cap and well as internal cap
is inserted completely into the burner’s venture funnel and that the burner rests firmly on its supports.
The burner should not rock side-to-side nor top-to-bottom if properly installed. If excessive burner
movement is present, reseat burner or contact your authorized service provider.