Alfresco ALF-PZA, Инструкция по использованию и уходу

Страница: 16 / 32

16
LIGHTING INSTRUCTIONS:
BEFORE LIGHTING LP SYSTEMS...
The pressure regulator (Type QCC1) and hose assembly supplied with the
Alfresco
™ Pizza Oven
must be used. Never substitute regulators for those supplied with the oven. If a replacement is
necessary, contact the factory for proper replacement.
NG SYSTEMS...
Make sure all connections are properly assembled whether is through the back or under the unit.
BUTTON SYMBOLS AND LOCATIONS:
The ignition and oven light buttons are located on the upper right
side of the front control panel.
The
Alfresco
™ Pizza Oven is equipped with
Gas safety valves. They do not operate if the
pilot flame or the burner goes off. To light the
pilot follow these simple steps :
•
Push and turn the gas control knob to the
PILOT position.
•
Push the ignition (spark) button.
•
Push the Gas Control Knob
The pilot should lit instantly. Continue
holding the gas knob for at least 5 ~ 10
seconds and release the gas control knob.
The pilot should remain lit.
(See Figure # 10)
If the pilot goes off, repeat the steps above until the pilot is constantly lit with the gas control knob
released. Please note that during the first start-up of the Pizza Oven, you might experience a delay in
the gas flow as the system purges itself of all existing air in the gas lines.
Once the pilot is lit, you can turn the knob to Hi to light up the IR or Log Burners. The Burners should
light up instantly.
When lighting, always keep your face and body as far away as possible from the burners.
NOTE: To ensure proper spark ignition, do not change the gap between the electrode wires and the
pilots. The optimum gap is preset at the factory between 1/8” and 3/16”.
IGNITER BUTTON SWITCH
(on RIGHT side)
LIGHT FIXTURE
(Located inside the oven)
Figure # 10
PUSH & TURN TO PILOT.
PUSH & HOLD .
PUSH TO
IGNITE